Wheel Spin (Without Guard); Wheel Spin (With Guard); Selection Of Adhesive Weights Application Position - SICE S 63 Manual De Instrucciones

In this condition, the first four grammes
of unbalance are not displayed since an
appropriate threshold, indicated by illumi-
nation of the
panel, is activated.
The key can be pressed to elimi-
nate the threshold (the illuminated indica-
tion "x5"; "oz/4" goes out) and the unbal-
ance values will be displayed gramme by
gramme (or in tenths of an ounce if display
in ounces is active).
Pressing the key consecutively allows the
user to set one display mode or the other.
WHEEL SPIN
(without guard)
The wheel spin is performed by pressing
the key .
WARNING
During machine use, personnel may not
be present in the area enclosed by the
sectioning in Fig. 5a.
WHEEL SPIN
(with guard)
Wheel spin takes place automatically when
the guard is lowered, or can be triggered
by pressing the START
guard lowered.
A special safety device stops rotation if the
guard is lifted up during the spin; in this
case, the " A Cr." message is displayed.
WARNING
56
LED on the display
key with the
Do not operate the machine without the
guard and/or if the safety device has been
tampered with.
WARNING
Never raise the guard before the wheel
has come to a stop.
WARNING
If the wheel keeps spinning permanently
due to a fault on the machine, switch off
the machine using the main switch or
disconnect the plug from the power supply
board (emergency stop) and wait until
the wheel stops before raising the guard.
SELECTION
OF ADHESIVE
WEIGHTS
APPLICATION
POSITION
The machine makes it possible for the
operator to select where the adhesive weight
should be applied based on his needs.
To select this configuration, proceed as
described below:
• Press either of the two key
and then, within two seconds,
press the
service programme 89 shown on the left
display. The flashing "Ent" message will
appear on the right display;
- Press the
• The message ALU will appear on the
key. This selects the
key to confirm;
User manual S 63