Installation; Installing The Electrical Connector Panel; Installing The Hard Lock Device - SICE A 926 Manual De Instrucciones

• Unpack the equipment, placing the packing in the position indicated above.
• Remove all the accessories from the pallet and from inside the machine, and set them down
nearby.
• Place the aligner in the desired position (see paragraph "Installation Clearances").
• Proceed to unpack the accessories.
• Remove the upper rear panel (A, fig. 14) of the aligner in order to access its interior.

Installing the electrical connector panel

Install the electrical connector panel at the top of the cabinet using the relative bracket (A, fig.
•
3). Connect electrical connector panel, using the relative extension, to one of the HDD power
cables leading out of the back of the PC and to the Hard Lock device with a USB cable (G, F,
fig. 11).

Installing the Hard Lock device:

Insert the tip of a pen into the hole at the side to open the SIM holder (fig. 47).
•
Remove the wheel aligner SIM card (fig. 46) from its punched backing card (keep the backing
•
card with the serial number for future queries) and insert in the SIM holder (fig. 47), with the
gold contacts facing upward.
Push the SIM holder in.
•
Fix the Hard Lock device (B, fig. 16) and the 2 charging cable retainer brackets (A, Fig. 16)
•
onto the back of the cabinet with the relative fastener screws.
Connect the 2 USB cables to the Hard Lock device: connect one to an unused USB port on
•
the PC; connect the other to the USB port on the electrical connector panel (E, F, fig. 11) by
passing through the hole on the cabinet (B, Fig. 3).
Connect the 4 sensor charging cables (with RJ45 connectors) to the electrical connector
•
panel (A, fig. 3) and fasten them into the 2 charging cable retainer brackets (A, Fig. 16) at the
back of the cabinet.
• Unpack the keyboard, place it on the shelf provided in the moulded casing (fig. 4) and insert
the data cable through the hole provided in the shelf.
• Remove the computer from its packing (keep the packing materials for future transport) and
place it in the compartment provided inside the cabinet (A, fig. 4bis).
• Remove the monitor from its packaging and fasten it to its support using the 4 screws (1, fig.
5) that are contained in the screw bag.
It is recommended to perform this operation with 2 people
• Connect the network cable (2, fig. 5) and the video cable (3, fig. 5) to the monitor.
Steering wheel holder and brake pedal depressor positioning
• Position the included STEERING WHEEL HOLDER and BRAKE PEDAL DEPRESSOR
accessories on the support brackets positioned on the back of the cabinet (Fig. 8).
• Pass the monitor cables through the hole on the rear side of the cabinet (fig. 3) to access the
computer compartment.
• Connect the monitor to one of the Shuko sockets available (fig. 3).
• Connect the monitor signal cable to the PC, as shown in fig. 11.
• Tie the power supply leads and monitor signal cables together outside using two straps.
• Connect the power supply, keyboard and printer (optional).

Installation

8