Setting Pump System Defaults; Figure 10. System Default Controls; Figure 11. Reset Defaults Menu - Johnson & Johnson DePuy Synthes FMS VUE II Manual Del Usuario

6.2

Setting Pump System Defaults

Default settings may be set after turning on power or before or after individual cases . Figure 10
summarizes pump default controls .
1 Press both Up (+) and Down (-) arrows at the same time to access the defaults . Press
the (+) or Down (-) arrows to view each default .
2 Custom Settings Indicator . Indicates that changes were made to factory settings .
3 Left Display shows custom default settings .
4 Right Display shows custom default options .
5 Press the Right Display Up (+) and Down (–) arrows to select the options for each
default in the order shown in Table 6 .
1. Access the Default Settings . With the main power ON, press the Left Display Up (
–
and Down ( ) arrows simultaneously . The Left (Pressure) Display shows the name of
the Default, and the Right (Shaver) Display shows Default options (Figure 10) .
2. Select the Default Name. Press the Left Display Up (
through the default menu selections .
3. Set the Default Options . Press the Right Display Up (
options for each default in the order shown in Table 6 .
4. Reset to Factory Defaults if required (optional) . A blue square in the upper left corner of
the Main Menu left display indicates that custom defaults have been modified from factory
defaults (see Figure 10) .
2 3
1
Figure 10. System Default Controls

Figure 11. Reset Defaults Menu

4
+
) and Down (
+
) and Down (
36
5
+
–
) arrows to navigate
–
) arrows to select the
)