Johnson & Johnson DePuy Synthes FMS VUE II Manual Del Usuario página 7

Preface
This manual describes the FMS VUE™ II Fluid Management and Tissue Debridement System,
and provides instructions for the proper use of the pump and accessories .
It is important to review this manual thoroughly before installing and operating the System .
Additional information, training, and product servicing are available from DePuy Synthes .
When using FMS VUE II accessories, please refer to the appropriate Instructions for Use
(IFUs) . IFU part numbers for each product are listed in Appendix B of this manual .
Read all instructions carefully . Refer to this manual when operating the FMS VUE II pump .
The information contained in this manual is based upon the most current information available
at the time of printing . Figures are representative .
The entire content of this manual is the property of DePuy Synthes and is protected by all
relevant copyright laws . Do not reproduce any portion of this manual, in any form, without
express written approval of DePuy Synthes . Worldwide Patents pending .
IEC-60601-1 Compliance
Intertek Semko evaluated the FMS VUE II Pump and its accessories for
Electromagnetic Compatibility, to regulations IEC 60601-1 3rd edition: 2005 and
IEC 60601-1-2 4th edition: 2014 . The pump and accessories were found to be
4008089
compliant .
FCC15C Labeling Requirement
FCC ID: 2AAVI-JDK2254
This device complies with part 15 of the FCC Rules . Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation .
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment .
Canadian Labeling Requirement
IC ID: 11355A-JDK2254
This device complies with the Industry Canada license-exempt RSS standard(s) . Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation
of the device .
7