Suction Settings; Flow+ Feature; Figure 12. Suction Settings; Table 8. Suction Settings - Johnson & Johnson DePuy Synthes FMS VUE II Manual Del Usuario

6.6

Suction Settings

6.6.1 FLOW+ Feature

Press the FLOW+ Suction or SHAVER Suction pads to increase the preset suction levels . The
orange LEDs illuminate to indicate the suction setting (Figure 12) .
The FLOW+ feature increases flow without increasing joint pressure . The SHAVER suction pad
increases or decreases flow through the handpiece . One light indicates minimum suction, two
lights low suction, three lights medium suction, and four lights indicate maximum suction .
There are two FLOW+ modes:
• Standard Mode: Press the FLOW+ button on the Foot Pedal to start FLOW+ . Release the
button to stop FLOW+ . If using a Shaver Handpiece, Standard Mode is activated when the
handpiece is turned on and deactivated when the handpiece is turned off .
• One Minute Mode: Press the FLOW+ button on the Foot Pedal for less than one (1) second
to activate FLOW+ . Suction levels will increase for 1 minute . To cancel FLOW+, press the
FLOW+ button at any time during the 1 minute cycle .
To...
Increase preset suction
levels .
Activate suction mode .
Activate the handpiece with
preset suction level .

Figure 12. Suction Settings

Table 8. Suction Settings

Do this...
Press the FLOW+ Suction or
Shaver Suction pads .
Press the left FLOW+ Foot
pedal /remote .
Step on the FORWARD,
REVERSE or OSCILLATE
Foot pedal .
41
System Response
As the suction level
increases, the number of
LEDs indicates suction
strength .
The adjacent indicator light
setting blinks when the flow
suction is activated as long
as the Foot pedal/remote is
pressed .
The adjacent indicator light
blinks when the handpiece
suction is activated .