Table 6. Pump Defaults - Johnson & Johnson DePuy Synthes FMS VUE II Manual Del Usuario

Setting
a. Reset to the factory
defaults:
+)
Press Up Arrow (
Right display . To keep existing
defaults and move to next
selection, press Down arrow
–
( ) on the Left Display .
b. REGULATION MODE
Set DUO or SOLO mode .
SOLO mode provides irrigation
only .
c. JOINT-TO-PUMP ELEVATION
Set Default elevation .
Range:+90cm (~3ft) above fill
level to -60cm (~2ft) below fill
level .
d. PRESSURE
Set Default pressure from 20 to
150 mmHg at startup .
e. DIRECTION (FWD or OSC)
Set shaver direction to Forward
or Oscillate .

Table 6. Pump Defaults

on the
37
Default Options