Dynamic Trial Fitting; Checking The Factory Settings - Ottobock 3R80 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 58
+ = anterior placement / – = posterior placement (in relation to the load line)
No.
see fig. 6
   
Optimise the static alignment solely by changing the plantar flexion. Adjustment is performed only
with the anterior and posterior set screws of the tube adapter on the prosthetic foot.
a–p positioning of the alignment reference point
the load line:
-35 mm

5.5 Dynamic Trial Fitting

CAUTION
Adjusting the Settings
Fall due to incorrect or unfamiliar settings
Only adapt the settings to the patient gradually.
Explain the effects of the adjustments on the use of the prosthesis to the patient.
During dynamic trial fitting, the alignment and settings of the prosthesis are checked and adapted
for optimum walking according to the needs and abilities of the patient.
The patient has to learn the safe use of the prosthesis through intensive training.
The following subsections describe the adjustment possibilities for adapting the product to the
patient.
The list below provides an overview of the sequence for working through the subsections:

Checking the Factory Settings

Setting Flexion Damping
Setting Extension Damping
Setting Stance Phase Damping
Setting the Stance Phase Damping Threshold
The adjustment is illustrated graphically in the supplied Quick Start Guide.
5.5.1 Opening the Covers
>
Tools required:
Flat screwdriver
1) Open the extension damping and flexion damping covers (see fig. 11).
2) Open the stance phase damping cover (see fig. 12).
5.5.2 Checking the Factory Settings
Function
Flexion damping
Extension damping
Stance phase damping
Stance phase damping
threshold
>
Tools required:
710H10=2x3 Adjustment Wrench
1) Check whether the settings match the factory settings (see table).
2) In case of deviations, restore the factory settings using the adjustment wrench.
Static Alignment Process
Means of adjustment
Adjustment valve "F"
(see fig. 13)
Adjustment valve "E"
(see fig. 14)
Adjustment ring "S"
(see fig. 15)
Adjustment ring "!"
(see fig. 16)
(rotation axis of the prosthetic knee joint) to
Factory setting
Stop "–"
Stop "–"
Stop "+"
Bumper
without
play,
pre-stressed
Meaning
Minimum damping
Minimum damping
Maximum damping
Low threshold
(stance phase damping is
activated at low load)
27

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

3r80-st

Tabla de contenido