Setting Parameters - SMA FUEL SAVE CONTROLLER 2.0 Instrucciones De Uso

4 User Interface
Button
Add new item
Adjust
Apply
Continue Wizard
Delete config.
Discard
Done
Remove item
Start
View
4.8.3

Setting Parameters

Risk of damage to devices by entry of incorrect parameters
Incorrect parameters may damage devices and result in system malfunctions in the PV diesel hybrid system. All
adjustable parameters are protected by the password of the user group Installer.
• Only a qualified person is permitted to set and adjust parameters.
• Only give the password for the user group Installer to qualified persons.
• Change the default passwords as soon as possible.
• Read the description of the parameters carefully and follow all instructions relating to the settings options of the
parameters.
Procedure:
1. Log in as Installer (see Section 5.1, page 21).
2. Select a menu via the page and menu selection.
3. Select desired parameter in the content area:
• To change parameters with an entry field, enter new values and press Enter after each entry.
By pressing Enter, the entered value is adopted in the user interface of the Fuel Save Controller.
• To change parameters with a checkbox, activate the required checkbox.
• To change parameters with a drop-down list, select the desired value in the appropriate drop-down list.
4. If the border of the input field flashes red, check the input and set the parameter to a valid value. To do this,
repeat the previous step.
5. To adopt current parameter settings in the control of the Fuel Save Controller, select the [Apply] button.
6. To discard current parameter settings, select the [Discard] button.
20 FSC20-BA-xx-20
Description
Add device type, e.g. a type of inverter
Adjust configuration of a subsystem
Save system settings
This saves all system settings in the active dialog. If you exit the active dialog
without saving the system settings, any system settings made since the last save
will be discarded.
Continue to the next dialog
Delete configuration of a subsystem
Discard system settings
Any system settings made in the active dialog and not saved by pressing the Ap-
ply button will be discarded.
Close the active dialog and switch to the overview of current system settings
Remove device type, e.g. a type of inverter
Start automatic configuration wizard
Show overview of current system settings
SMA Solar Technology AG
User Manual