Setting The Temperature And Irradiation Sensors - SMA FUEL SAVE CONTROLLER 2.0 Instrucciones De Uso

7 System Settings
Procedure:
1. Select the menu Configuration Wizard via the page and menu selection.
2. In the Measurement System bar, click on the button [Adjust].
3. In the menu Measurement devices general configuration, first click on the button [Apply] and then on the
button [Continue wizard]. This opens the menu Measurement devices detailed configuration.
4. In the Assign measurement points bar, click on the button [Show devices].
5. To add a device, perform the following steps:
• Select the appropriate subsystem via Select a subsystem.
• In the area Select a measurement point select either one available device or all available devices:
– To select one available device, activate the checkbox for this device.
– To select all available devices, activate the checkbox Select all.
• Click on the button [Add >>].
• Click on the button [Apply and close].
6. To remove a device, perform the following steps:
• In the area Select a measurement point select either one active device or all active devices:
– To select one active device, activate the checkbox for this device.
– To select all active devices, activate the checkbox Select all.
• Click on the button [<< Remove].
• Click on the button [Apply and close].
7.6

Setting the Temperature and Irradiation Sensors

The system settings of the Fuel Save Controller can only be adjusted when the Fuel Save Controller is in STANDBY or
ERROR mode. The operating state STANDBY can be reached by stopping the SMA Fuel Save Controller.
Meteorologic general configuration
Figure 24: System settings for the temperature and irradiation sensors
62 FSC20-BA-xx-20
SMA Solar Technology AG
User Manual