Parameters For Gensets With Genset Controller Easygen-3000 Via The Can Network - SMA FUEL SAVE CONTROLLER 2.0 Instrucciones De Uso

SMA Solar Technology AG
Parameter Description
Enable this gen- Determines whether the
erator Fuel Save Controller should take
the genset into account for con-
trol of the PV diesel hybrid system
Nominal active Nominal power of the genset
power
7.2.2 Parameters for gensets with genset controller easYgen-3000 via the CAN
network
Genset general configuration
Parameter Description
Remaining Remaining number of config-
available de- urable gensets
vices
Number of de- Number of installed gensets
vices
Genset inter- Type of genset interface
face Type
CAN#1 pass- Password for write access to the
word genset controller
Genset setpoint Activates the writing of reserve
mechanism power setpoints to the genset
controller system (see Sec-
tion 8.1.1, page 70).
* For settings regarding the genset controller, see technical information "Gensets in PV Diesel Hybrid Systems with
SMA Fuel Save Controller 2.0"
Generator configuration wizard: detailed configuration
Parameter Description
Label Genset / genset controller ID
User Manual
Value Explanation
Yes The Fuel Save Controller
takes the genset into ac-
count.
No The Fuel Save Controller
does not take the genset
into account.
0 kW to 10000 kW –
Value Explanation
– –
0 to 8 –
Easygen 3000 CAN Genset controller "Wood-
ward Easygen 3000" with
CAN communication *
0 to 9999 For setting the password,
refer to manufacturer docu-
mentation
Checkbox activated The specification of set-
points for the reserve
power is activated
Checkbox deacti- The specification of set-
vated points for the reserve
power is deactivated
Value Explanation
– –
7 System Settings
Default
value
No
0 kW
Default
value
–
0
None
–
Deacti-
vated
Default
value
–
FSC20-BA-xx-20 45