Parameter Description - SMA FUEL SAVE CONTROLLER 2.0 Instrucciones De Uso

7 System Settings
Parameter Description
Enable this gen- Determines whether the
erator Fuel Save Controller should take
the genset into account for con-
trol of the PV diesel hybrid system
IP address ID address of the genset con-
troller (not applicable with a
higher-level control system)
Unit ID (Mod- Genset controller ID
bus/TCP)
Nominal active Nominal power of the genset
power
PDO-ID Proto- Genset controller ID for the proto-
col 6000 col 6000 (load distribution mes-
sage)
PDO-ID Proto- Genset controller ID for the data
col 5003 protocol 5003 (basic visualiza-
tion)
Service Data Genset controller ID for communi-
Object ID cating via Service Data Objects
(SDO)
Timeout for Timeout for transfer according to
PDO-ID Proto- protocol 6000
col 6000
Timeout for Timeout for transfer according to
PDO-ID Proto- data protocol 5003
col 5003
Timeout for Ser- Timeout for communication via
vice Data Ob- Service Data Objects
ject ID
CAN message Display of the current capacity
buffer load used in the CAN message store
46 FSC20-BA-xx-20
Value Explanation
Yes The Fuel Save Controller
takes the genset into ac-
count.
No The Fuel Save Controller
does not take the genset
into account.
172.16.1.31 to Address range defined by
172.16.1.38 the Fuel Save Controller for
gensets
1 to 254 –
0 kW to 10000 kW –
0 to 2047 For more information on the
genset controller, see the
manufacturer documenta-
tion
0 to 2047
0 to 2047
20 ms to 60000 ms The specification for the
timeout must be higher than
the cycle time configured in
the genset controller (for
20 ms to 60000 ms
more information on the
genset controller, see the
manufacturer documenta-
tion).
20 ms to 60000 ms
0% to 100% The load in the CAN mes-
sage store is only dis-
played after restarting the
Fuel Save Controller (see
Section 10.3, page 100).
SMA Solar Technology AG
Default
value
No
–
–
0 kW
1280
385
1537
250 ms
250 ms
500 ms
0 %
User Manual