Configuring Stop Of The Fuel Save Controller Via Switch Input Di 7 - SMA FUEL SAVE CONTROLLER 2.0 Instrucciones De Uso

SMA Solar Technology AG
Parameter Description
Remaining available Remaining number of config-
devices urable temperature and irradia-
tion sensors
Number of devices Number of temperature and irra-
diation sensors installed
Device type Type of temperature and irradia-
tion sensors
Requirement:
☐ You must be logged in as Installer.
Procedure:
1. Choose the menu Configuration Wizard via the page and menu selection.
2. In the Meteorological data bar, select the [Adjust] button.
3. Set the parameters in the menu Meteorologic general configuration (see Section 4.8.3, page 20).
4. To continue with system settings, select the [Continue wizard] button.
5. Select the [Done] button.
6. End the system settings (see Section 7.9.1, page 67).
7.7

Configuring Stop of the Fuel Save Controller via Switch Input DI 7

The system settings of the Fuel Save Controller can only be adjusted when the Fuel Save Controller is in STANDBY or
ERROR mode. The operating state STANDBY can be reached by stopping the SMA Fuel Save Controller.
User Manual
Value Explanation
–
0 to 6
SMA Me- Interface to the SMA Cluster Con-
teo Sta- troller or SMA Inverter Manager
tion
SMA Me- Only make adjustments after
teo Sta- prior consultation with SMA So-
tion Mod- lar Technology AG
bus TCP
Sunspec Communication interface speci-
Mini Met fied according to SunSpec Mod-
Model bus
7 System Settings
Default
value
– –
– 0
SMA Me-
teo Sta-
tion
FSC20-BA-xx-20 63