The Estimated Charge Time applies to rechargeable Stimulators only. The Estimated Charge Times provides an estimate of the duration and frequency of charging

necessary to maintain stimulation for the selected Program. After the optimal settings have been identified for a Program, from the Program Tab, select Program

Options and then select Battery to obtain the Estimated Charge Time.

Elective Replacement Indicator (ERI) Message

You will not be able to connect to a non‑rechargeable Stimulator that is nearing the end of its battery life. The CP will display the Stimulator with an ERI message

and the Stimulator battery voltage as shown in Figure 17 on the Connect Tab. During the ERI period, the Stimulator will continue to provide stimulation; however, no

changes can be made to the Stimulator setting.

Note: The ERI Message applies to non‑rechargeable Stimulators only.

End of Service (EOS) Message

When the Stimulator has reached its end of service, stimulation will no longer be provided. The CP will display the message shown in Figure 18 on the Connect Tab.

Note: The EOS Message applies to non‑rechargeable Stimulators only.

Ending a Programming Session

To end a Programming Session on the CP:

1. Select the End Session Tab.

2. Select Exit Application to end the programming session and close the application.

3. Alternatively, select Disconnect from Stimulator to end the programming session and disconnect from the patient's Stimulator. This will take you back to the

Connect Tab.

All Programs and programming data are automatically saved in real‑time during the programming session. No step to actively "save" is required. The Patient's

Remote Control automatically syncs with the Stimulator to which it has been linked.

Figure 17. ERI Message Displayed on Connect Tab

Figure 18. EOS Message Displayed on Connect Tab

Additional Information

Vercise™ Neural Navigator 3 Programming Manual

92348958‑06 17 of 477

Tabla de Contenido