Boston Scientific Vercise Instrucciones De Uso página 7

5. Once a connection has been established between the CP and the Stimulator, the following screen will appear (Figure 4).
# Feature Description
1 Patient ID Displays the Patient ID number.
Displays the connection status between the CP, Wand, and Stimulator along with the Model and Serial Number of each of the
devices.
# Connection Status
1
2 Connection Status
2
3
3 Rescan Button Scan for available Stimulators. Disabled if the CP is already connected to the Stimulator.
4 Connection Status Displays a green filled circle if the Stimulator is connected to the CP.
Connect or Connect or disconnect from a Stimulator. When a Stimulator is not connected, this button reads 'Connect'. When a Stimulator is
5
Disconnect Button connected, this button reads 'Disconnect'.
Figure 4. Connection Established Between CP and Stimulator
Table 2: Description of the Connect Tab
Description
Connection between CP, Wand, and Stimulator was established.
Connection between Wand and Stimulator not established. Move the Wand closer to
the Stimulator and Rescan.
Connection between CP, Wand, and Stimulator not established. Check the USB cable
connections to the Wand, move the Wand closer to the Stimulator and Rescan, and/
or refer to the Vercise DBS Programming Wand Manual for more information.
Starting a Programming Session
Vercise™ Neural Navigator 3 Programming Manual
92348958-06 3 of 477