Jungheinrich EKS 314 Manual De Instrucciones página 50

3.7.1 Picking up a load from the front.
IMPORTANT Before collecting the load the driver must ensure that the pallet clamp is open.
– Apply the foot switch (37).
– Drive the truck slowly.
– Slowly insert the forks into the pallet until
the fork shank touches the load or the pal-
let.
– Raise the load slightly.
– Clamp the load by pressing the "Pallet
Clamp" switch (9).
– Check on the display (7) in the control pan-
el that the load has been clamped.
– Slowly reverse the truck.
IMPORTANT The ground surface must be in good
condition
correctly.
3.7.2 Transporting a load
– Apply the foot switch (37).
– Always transport a load outside the rack aisle as low as possible, allowing for
ground clearance.
– Always transport loads with both forks. When transporting heavy loads always en-
sure that both forks carry an equal weight.
– Gradually accelerate.
– Drive at constant speed.
– Always be prepared to brake. Only stop suddenly in emergency situations.
– Reduce speed accordingly at narrow bends.
to ensure this works
9 7
E 21