Jungheinrich EKS 314 Manual De Instrucciones página 89

Hydraulic 6.1 Test operation
System
6.2 Check connections and ports for leaks and damage
6.3 Check hydraulic cylinder for leaks and damage and
6.4 Check oil level
6.5 Test hose guide and check for damage
6.6 Check ventilation and discharge filter on hydraulic reser-
6.7 Replace ventilation and discharge filter on hydraulic res-
6.8 Replace hydraulic oil and filter cartridge
6.9 Test pressure relief valves
6.10 Make sure hydraulic hoses are sealed and check for
6.11 Test line brake safety device
Electrical 7.1 Test static charge eliminator
System
7.2 Test operation
7.3 Make sure wire connections are secure and check for
7.4 Test the operation of the cable guides and check for
7.5 Test operation of warning devices and safety switches.
7.6 Make sure sensors are fixed, not damaged, clean and
7.7 Test operation of instruments and displays
7.8 Check contactors and relays; if necessary replace any
7.9 Check fuse ratings
Electric 8.2 Check motor attachment
Motors:
Battery: 9.1 Check acid density, acid level and cell voltage
9.2 Check terminals are securely attached, and apply
9.3 Clean battery connections, make sure they are secure
9.4 Check battery cables for damage, replace if necessary.
p) Replace hydraulic hoses after 6 years' operation
G 8
make sure it is secure
voir
ervoir
damage.
damage
damage
operational
worn parts
grease
Maintenance intervals
t
Standard =
p)
W A B C
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t