Slack Chain Safety Device Override; Travel Cutout Override (O); Lift Limit Override (O) - Jungheinrich EKS 314 Manual De Instrucciones

5.8

Slack chain safety device override

If the slack chain safety device has actuated, e.g. when position-
ing the load handler, loosening or braking the lift chain, the "slack
chain safety device" symbol (50) illuminates in the display unit. It
is possible to raise the Main Lift if the slack chain safety device
override switch (51) is depressed and held down while pressing
the hydraulic control button. Travelling and lowering are now in-
hibited.
Before starting again, diagnose and correct the problem that
caused actuation of the device.
IMPORTANT The truck can only be started again when the problem has been corrected.
5.9

Travel cutout override (o)

If travel is inhibited from a certain lift height (the "Travel cutout
override" symbol (52) appears in the display), and the position of
the truck relative to the rack must be adjusted to load or unload
goods, press the "unlock travel" switch (53) and apply the travel
control button as described in "Travelling". This allows you to trav-
el at crawl speed.
5.10

Lift limit override (o)

If local conditions require, an automatic lift cutout wich limits max-
imum lift height can be fitted for safety reasons. The display unit
shows the "Lift Cutout Override" symbol (54).
IMPORTANT Lift cutout only becomes effective after a test run has
been carried out. You can tell when this is the case,
because the actual height is shown in the display unit.
Pressing the "lift cutout override" switch (55) disables the
lift cutout.
Qw W
When disabling the lift cutout the driver must look out for obstacles when the
mast is extended.
NOTICE Lift cutout is re-activated each time the mast falls below the lift limit height.
The respective travel and lift limit switches are located in the control panel.
50
51
52
53
54
55
E 41