Lifting - Lowering - Outside And Inside The Rack Lanes; Diagonal Travel - Jungheinrich EKS 314 Manual De Instrucciones

3.5 Lifting – Lowering – outside and inside the rack lanes
Qw W
There is a risk of injury when the driver's cab and the load lifting device are
lowered. There must be nobody in the danger zone.
Lift – Lower (Main Lift)
– Apply the foot switch.
– At the same time, turn the hydraulic control button (2) "up"
- in drive direction (L) = lower
- in load direction (R) = raise
or
At the same time, turn the hydraulic control button (2) "down"
- in drive direction (R) = raise
- in load direction (L) = lower
NOTICE The lift and lower speeds are proportional to the degree of turn of the
hydraulic control switch.
NOTICE If the line break safety device actuates at a non-permitted lowering speed
(Error: Er 287), determine the cause and if there no leakage in the hydraulic
system, briefly raise the Main Lift and then lower it again.
3.6

Diagonal travel

Qw W
Diagonal travel (simultaneous travel and lifting/lowering) is possible when
you press the hydraulic control button (2) while simultaneously depressing
the travel control button (1).
Raise (R)
Lower (L))
2 "up"
L
R
2 "down"
E 19