Park The Truck Securely - Jungheinrich EKS 314 Manual De Instrucciones

3.7.3 Depositing a load
– Drive the truck carefully up to the storage location.
IMPORTANT Before a load can be deposited, the driver must ensure that the storage
location is suitable for storing the load (size and capacity).
– Apply the foot switch (37).
– Raise the load lifting device so that the
load can be taken to the storage loca-
tion without striking any objects.
– Carefully push the load into its storage
location.
– Open the pallet clamp by pressing the
"Pallet Clamp" switch (9).
– Check on the display (7) in the control
panel that the pallet clamp is open.
– Carefully lower the load lifting device
so that the forks are clear of the load.
IMPORTANT Avoid placing the load down
suddenly to avoid damaging the
load and the load lifting device.
– Carefully remove the load lifting de-
vice from the load.
– Fully lower the load lifting device.
3.8

Park the truck securely

When you leave the truck it must be securely parked even if you only intend to leave
it for a short time.
Qw W
Do not park the truck on an incline. In special cases the truck may need to be
secured with blocks or chocks.
NOTICE Select a parking place where nobody will collide with the forks.
– Always park the truck with the mast completely lowered.
– Lower the forks to the ground.
– Set the key switch to "0" and remove the safety key.
E 22
9 7