Gima CMS8000 Manual Del Uso página 154

Inserting Paper
• Open the recorder catch.
• Insert a new roll of paper into the paper cassette, printing side facing the thermosensitive printhead.
• Give out the paper from the recorder outlet.
• Close the recorder catch.
Note
• Be careful when inserting paper. Avoid damaging the thermosensitive printhead. Unless when inserting
paper or shooting troubles, do not leave the recorder catch open.
• Removing Paper Jam.
• When the recorder functions or sounds improperly, open the recorder catch to check for a paper jam. If the
paper jam only re-insert the paper.
a) Recorder Status Message (Technical Alarms)
Message
RECORDER HEAD HOT
REC HEAD IN WRONG POS.
RECORDER OUT OF PAPER
RECORDER COMM ERR
RECORDER PAPER JAM
RECORDER INITIALIZING
TOO MANY REC TASKS
RECORDER PAPER W.P.
RECORDER BUSY
REC NOT AVAILABLE
RECORDER VLT HIGH
RECORDER VLT LOW
RECORDER S. COMM ERR
RECORDER SELFTEST ERR
RECORDER INIT ERR
RECORDER INIT ERR1
RECORDER INIT ERR2
RECORDER INIT ERR3
RECORDER INIT ERR4
RECORDER INIT ERR7
RECORDER INIT ERR8
After shutdown and re-start, if error still exists, contact out service engineers.
Cause
The thermal terminal is too hot.
The thermal head is not in recor-
ding place.
Record paper runs out.
Operating status error
Recording continuously for more
than 30m.
The recorder is in initialization
process.
Too many alarm events take pla-
ce simultaneously.
The paper is in wrong position.
In the status of printing out
Recorder stops working.
The voltage of the recorder
is too high.
The voltage of the recorder
is too low.
Unrecoverable serial port
communication error.
Possibly caused by the RAM,
ROM, CPU or WATCHDOG.
Error occurs during initialization
Error occurs during initialization
Error occurs during initialization
Error occurs during initialization
Error occurs during initialization
Error occurs during initialization
Error occurs during initialization
Alarm Remedy
Level
Low Stop operation
Low Push down the switch on the
left axis of the recorder.
Low Insert a new roll of record
paper.
Low Reset the recorder.
Low Re-insert paper.
Low Wait for the completion
of initialization
Low Send recording order after
a while.
Low Insert the record paper again.
Low Wait for the completion
of printing out
Low Give recording order after
the recorder restores to
the normal status or the failure
is removed.
Low Stop recording until the
recorder restores normal
status.
Low Stop recording until the
recorder restores normal
status.
Low Shut down the monitor
and re-start it again.
Low Reset the recorder.
Low Shutdown and re-start
Low Shutdown and re-start
Low Shutdown and re-start
Low Shutdown and re-start
Low Shutdown and re-start
Low Shutdown and re-start
Low Shutdown and re-start
34