Trend Table - Gima CMS8000 Manual Del Uso

Operation example
To view the NIBP trend graph of the last 1 hour:
• Pick the MENU hot key lower right of the screen.
• Pick TREND GRAPH item.
• Pick the first item and switch to NIBP by turning the knob.
• Adjust the second item to be 1 or 5 sec.
• Pick the ZOOM button and turn the knob to view changes of the trend graph time and trend curve.
• Stop at requested trend time section for careful review. Pick the ZOOM button to adjust the display scale if
necessary.
• For measurement result of a specific time, pick CURSOR to move the cursor to the point, corresponding
time and value will display on above and below respectively.
• For printout of trend graph, pick REC to start report printing of NIBP trend of this hour.
• Pick EXIT to return to trend graph display.

7.2 trend table

• The latest 480-trend table data can be displayed at every 1, 5, 10, 30, or 60 minutes.
Pick TREND TABLE in the SYSTEM MENU to call up the following menu:
Figure 7-2 Trend Table Menu
Time in response to each group of trend data is displayed at the leftmost list with date in bracket. Marked
event corresponds to marking time. Trend data of each parameter is divided into 8 groups.
HR, PVCS
ST1, ST2
RR
T1, T2, TD
SpO , PR
2
IBP1(S/D/M), IBP2(S/D/M)
CO2, INS, AwRR
NIBP (S/M/D)
NIBP trend data presents different specificity. A certain NIBP measuring time is displayed below the TEST AT
item, as well as the measurement value. For more than one measurement in one time, it can display only one
group, and mark a "*" on the MORE to indicate two and above measurement results.
To choose trend table of different resolution
Pick the leftmost item and change the time interval of trend data.
To view other trend data:
When — appears on the upper part of the screen, pick UP-DOWN button and turn the knob clockwise to
view later trend data. When ˜ appears on the lower part of the screen, pick the same item and turn the knob
counterclockwise to view earlier trend data.
To obtain trend data of different parameter
Pick L-RIGHT to select one from the 8 groups of parameters. A ">" by the rightmost item indicates following
page available. And "<" by the leftmost item indicated previous page available.
36