Continuation Stops - Hettich BlueMax Mini Modular Instrucciones De Servicio

Start up / trial run
Centre stop installed in the bench top.
Fasten the centre stop at the side using screws
Always follow the assembly instructions!
en

Continuation stops

The continuation stops are premounted on the Interchangeable
drilling unit, 9 spindles.
Setting the continuation stops
Setting height of the continuation stop
The height of the left and right continuation shop must be
adjusted to suit the panel thickness by means of top setting ring
. The continuation stop's finger should engage as deeply as
1
possible into the drill hole. A space of approx. 3 mm must also
be allowed between workpiece and stop (insert a 3 mm hexagon
socket spanner )
2
124
provided.
4
1
2
4