Checking Switch For Proper Working Order; Inserting Position For Press-In Frame - Hettich BlueMax Mini Modular Instrucciones De Servicio

Checking switch for proper working order

The 6 spindle interchangeable drilling unit is used for drilling
holes and for inserting a hinge / connector.
The drilling unit's drive system must be switched off for
inserting the hinge / connector.
Using the hand lever , turn press-in frame
2
inserting position. Operate switch
motor off using the switch. Check for proper working order.
Adjust the switch if necessary.
Switch must always be checked for proper working order
1
after changing the drilling unit or after the machine has been
out of service for a prolonged period.
Danger!
Malfunctioning can result in serious injuries
and disrupt production!
The press-in frame can be repositioned if necessary.
2
Adjust press-in frame for exact positioning
using setscrew .
4
The setscrew presses against stop screw
Swing down press-in frame
2
during pressing in.
If necessary, repeat the setting process until the correct
position is attained.
into the
3
with the lever and turn
1
.
5
and check position
1
2
3
4
5
2
en
139