Servicing / Care; General Information Working On Electrical Components; Instructing Maintenance Personnel - Hettich BlueMax Mini Modular Instrucciones De Servicio

Servicing / care

9. Servicing / care
1. General information
Working on electrical components

2. Instructing maintenance personnel

3. Making the machine safe on shutdown
4. Cleaning the machine
Electric motors
5. Servicing work
Work on the pneumatic system
Servicing unit
6. Instructions on inspections
General
en
154
1. General information
Inadequate, improper and / or unpunctual servicing
will increase risk potential and may lead to operating
154
malfunctions, high repair costs and long down times.
The risk is borne solely by the owner.
154
Working on electrical components
154
Faulty electrical components must only be replaced with
155
replacement parts of identical design.
155
Before attempting any work on electrical equipment, always
155
disconnect it from the power supply and consult qualified
personnel.
155
Danger!
155
Electrical operating equipment as well as specific
156
parts of these devices may carry a dangerously high
156
level of voltage even when they are switched off.
156
For this reason, handling electrical operating equipment
improperly may result in serious damage and / or damage to
property.
Warning!
Electrical equipment must only be repaired by
qualified personnel.
Before attempting any work, reliably disconnect the relevant
device from the mains power supply and earth it. Only use
approved replacement parts (e.g. fuses) with specifications
that match the data in the equipment parts list.
2. Instructing maintenance personnel
Before attempting any work, familiarise yourself with the
machine as well as with this operating manual and always
work in a way that meets the safety requirements.
Also follow any non Hettich operating instructions in the
appendix to this operating manual.
Before attempting any maintenance measures, make sure
that:
• the machine has been shut down and prevented from
switching back on again and cannot be started up
unintentionally or by mistake, and
• the compressed-air supply to the machine is shut off and
the machine is depressurised.
all intended work is brought to the attention of a supervising
person.
Warning!
Immediately renew worn and / or damaged
components.
Otherwise, you will jeopardise your personal safety,
the machine's operating safety and the safety of your
surroundings.