Setting Up; General Information Safety Precautions Information For The Machine Setter; Getting Ready; Tools / Aids - Hettich BlueMax Mini Modular Instrucciones De Servicio

Setting up

7. Setting up
1 . General information
Safety precautions
Information for the machine setter

2. Getting ready

3. Tools / aids

4. Safety check

5. Setting up (preparing for work)
Tools used (drill bits)
Interchangeable drilling unit, 6 spindles,
interchangeable drilling unit, 3 spindles (Selekta 22/9) 136
Interchangeable drilling unit, 9 spindles
Interchangeable drilling unit, 90°, 9 spindles
6. Changing interchangeable drilling units
Cleaning
en
Fitting drilling units
Checking switch for proper working order
Inserting position for press-in frame
Setting drilling depth
Drilling penetration rate (end-position damping)
Limiting drilling stroke for drilling hole lines
7. Hold-down clamp and centre stop
Hold-down clamp
Centre stop
8. Bench top edge distance
Pendulum stops
134
1. General information
Safety precautions
134 Any person given the task of operating, servicing and
repairing this machine or of altering its settings must have
134
read, understood and adhere to the operating manual, in
particular to the safety precautions.
134
The authorities and tasks of personnel operating this machine
134
must be clearly defined.
134
The work described in this section must only be carried
out by appropriately qualified personnel who are perfectly
134
familiar with this machine / system.
135
Information for the machine setter
135
All work involved in repairing, setting, troubleshooting
and servicing must only be carried out by duly instructed
and authorised skilled personnel. In the interest of safety,
a second person must be present during all work in case
136
hazardous situations occur.
136
2. Getting ready
137
Note!
137
Before setting the machine, familiarise yourself with
its controls.
138
139 Before you start setting:
139 • Look at the production job to find out which settings need
making.
140
• Check the machine for any damage.
140
• Make sure the machine is safe and in proper working order
141
before and after you switch it on.
142
• Make sure the described basic settings and trial runs have
been made and the machine is ready for operation.
142
• When switching the machine on, make sure no
143
unauthorised persons are present in the machine's work
143
area.
143
3. Tools / aids
• All tools and aids must be in proper working order.
4. Safety check
Satisfy yourself that
• installation, set-up and servicing work have been
completed in full and no persons are present in the danger
zone, let alone working on it,
• all safety guards / covers are in place.
Danger!
Never put the system into operation if work is still
being performed on this machine.
Establish the cause of any malfunction with the machine
shut down and made safe and have it rectified by a qualified
and skilled person trained to do so.
Or eliminate the malfunction yourself if you are in possession
of the necessary qualification.
Caution!
Only switch the machine back on again once
malfunctions / faults have been properly and
completely rectified!