Clearing (Unclogging) - Nogueira FTN-1900 Manual De Instrucciones

5.10- Clearing (unclogging)

In case of 'clogging' the harvester, unclog the
feeding rollers using the inverter tool supplied
with the machine (figure on the side).
In the event of a 'clogging', immediately
turn off the tractor and remove the key
from the ignition.
NEVER TRY TO UNBLOCK THE MACHINE
WITH THE TRACTOR ON! RISK OF SERIOUS
ACCIDENT!
Keep the inverter tool always with the
machine, so it will be available whenever
necessary.
'UNCLOGGING' PROCEDURE:
Immediately stop the tractor and
1.
disconnect the power take-off;
Remove the key from the ignition;
2.
Check that the safety pin of the machine
3.
has broken. If it is broken, replace it with
a new one. To change the safety pin, see
item 6.10 "SAFETY PINS".
Take the inverter tool (G) and the handle
4.
(H) from the tool box that comes with
the machine;
Remove bolt (E) from protective cover;
5.
Lift the protective cover (F);
6.
DANGER!
ATTENTION!
Instructions Manual
INVERTER TOOL
G
H
5. Operation
87