Type Key - Grundfos TPE2 D Manual Del Usuario

4.2 Type key

Code Example
Pump range, electronically speed-controlled pump
TPE2 Without built-in sensor
TPE3 Built-in differential-pressure and temperature sensor
Twin-head pump
Nominal diameter of inlet and outlet ports [mm]
Maximum head [decimeters (dm)]
S Built-in differential-pressure and temperature sensor
N Without built-in sensor
Code for pump version:
A Basic version
X Special version
Code for pipe connection:
G ANSI flange
Code for materials:
A Basic version
I Stainless steel CF8 (1.4308) pump housing and motor stool
Code for shaft seal including other plastic and rubber pump parts, except the neck ring
Code for NEMA motors [hp (kW)]:
C 0.33 (0.25)
D 0.5 (0.37)
E 0.75 (0.55)
F 1 (0.75)
G 1.5 (1.1)
H 2 (1.5)
I 3 (2.2)
Code for phase & voltage and other information:
A 1 x 200-240 V
B 3 x 200-240 V
C 3 x 440-480 V
D 3 x 380-500 V
Y Out of DOE scope (department of energy)
Code for speed variant [rpm]:
A 1450-2200
B 2900-4000
C 4000-5900
4.2.1 Codes for shaft seal
Code Example
Grundfos type designation
A O-ring seal with fixed seal driver
B Rubber bellows seal
D O-ring seal, balanced
G Bellows seal with reduced seal faces
R O-ring seal with reduced seal faces
Material of rotating face
A Carbon, antimony-impregnated
B Carbon, resin-impregnated
Q Silicon carbide
Material of stationary seat
B Carbon, resin-impregnated
Q Silicon carbide
U Tungsten carbide
Material of secondary seal
E EPDM
P NBR rubber
V FKM
F FXM
8
TPE3 D 65 -150 S -A -G -A -BQQE -G
B Q B
C B
E