GASPARDO MTE Empleo Y Mantenimiento página 57

DISTRIBUTION ADJUSTMENT
Distribution adjustment must be done in compliance with:
- the kind of seed that has to be distributed;
- the longitudinal distance between one seed and another.
Kind of seed to be distributed:
Identify the diameter of the holes of the seed disk in Table 3, ac-
cording to the type of seed to distribute.
For special requirements make a specifi c order.
The values shown on the table are approximate. The defi nite
choice of seed plates is completely up to the user. Complaints
for imprecise sowing due to utilization of improper seed plates
will not be accepted.
Longitudinal distance between one seed and another:
The longitudinal seeding distance is determined by the number of
holes on the seed plate, by the number of teeth and position of the
gears on the wheel which transmits the motion to the gearbox, and
by how the gears are combined in the gearbox. The seed spacings
shown in the table are only indicative values since they are affected
by different working conditions; we therefore advise you to check
the actual spacing of the seeds in practice.
The Manufacture will not be held liable for any inconsistencies
between the values of the table and the actual values found.
On the cover of the gearbox there is a table for adjusting the se-
eding distance and a table that shows the drive fi tted on the gear
drive wheel.
Table 3
(*) Special for beans.
(**) The seed distributor cover should be replaced by a special one suitable for small seeds.
For special requirements make a specifi c order. The values shown on the table are approximate. The defi nite choice of seed plates
is completely up to the user. Complaints for imprecise sowing due to utilization of improper seed plates will not be accepted.
cod. G19503270
USE AND MAINTENANCE
1) From the Seed Investment Table:
Depending on both the row distance of the planter and the selec-
ted seed investment per hectare, calculate the longitudinal seed
planting distance by using Table 2 (Seed Investment Table).
Example:
- Seeding row distance 75 cm;
- number of seeds to be distributed per hectare: 72.000.
According to the "Seed investment Table", the longitudinal distance
between one seed and another is 18,50 cm.
For row distances differing from those listed in the table, apply the
following directions:
Longitudinal seeding distance =
Example:
- Ha = 10000 m
- Row distance = 0,90 m;
- No. of seeds to be distributed for hectare = 70.000
Longitudinal seeding dist =
(cm)
2) About the Seed Planter:
Verifi y which couple of pinions (Wheel) is to be found (C-D ill. no.
25) in the seed planter;
C
fi g. 25

(
Ha
Row distance
No. of seeds/ha
2
;
( )
10000m 2
0,90
70000
D
ENGLISH
)
X 100
X 100 = 15,87 cm
57