Gima 35132 Manual De Uso página 99

AC Power indicator
ON
OFF
Status
ON
5. SpO : SpO sensor connector
2 2
6. NIBP: NIBP hose connector
7. TEMP: TEMP probe connector (optional)
8. " "NIBP Setup key: A shortcut key to change NIBP measuring mode and cycle time for Auto mode.
9. " "ECG lead selection key: A short press of this key to shift ECG lead, holding this key and pressing
NIBP setup key (8) will lock or un-lock the key operation.
10. " " Alarm silence key.
11. " " Print.
12. " " NIBP Operation key: Press it to start/cancel NIBP measurement.
13. " " Up: Shift cursor forward/upward.
14. " " OK: When in setting menu, press it to confirm selection or modification; On history record
screen, long pressing this key, then a deleting dialog pops up; On monitoring screen, short pressing to
freeze/unfreeze ECG waveform.
15. " "Down: Shift cursor backward/downward.
16. " " Display View key: Short pressing to shift LCD display views or return to the upper level screen;
long pressing to enter into root setting menu display screen.
17. " ": LCD panel
Note: 1). " ": Type BF Applied Part with Defibrillation-proof
2). Long pressing means press and hold for 2 seconds.
BP value can be displayed in two units, "×××" mmHg" or "××.×" kPa, refer to section "4.7.2 NIBP Setup" to
set the display unit of BP value. The conversion between two units is: 1kPa=7.5mmHg. 1mmHg=0.133kPa.
User Manual for Vital Signs Monitor
DC Power indicator
ON
ON
OFF
8
Descriptions
this device is on and using AC power supply
the device is on and using built-in battery
the device is off and battery is being
charged while the AC power is connected.