Loading Printer Paper (If Printer Is Installed) - Gima 35132 Manual De Uso

u Connecting methods for thermal temperature transducer:
1. Securely attach the transducer to the patient;
2. Connect the cable to TEMP probe connector in the front panel.
u Connecting methods for infrared temperature probe:
Temperature
probe cover
Display screen
Power on/off key
Battery cover
MConnect the infrared temperature probe to the connector on the front side of device marked
"TEMP".
MWhen the probe screen shows as figure 3.11B and the temperature unit "℃" is blinking, the user can
begin to take the measurement.
MInsert the tip of the temperature probe into the earhole and press the measuring key to start the
measurement. A short beep means the measurement has finished and the result will be displayed on
the both probe and the monitor screen .
Note: When unplugging the probe, be sure to hold the head of the connector and pull it out.

3.4.5 Loading printer paper (if printer is installed)

Operation procedures for loading printer paper:
1. To open the printer cover, press two thumbs firmly on both "OPEN" notches.
2. Move the tab of the left rubber roller lock 90°upwards to unlock it, refer to the following figure with
mark ①.
3. Cut one end of the paper into a triangle, and load the paper from the underside of the rubber roller.
4. Turn the roller clockwise to roll the paper rolled, and put the paper roll into the compartment.
5. Pull the paper out of the paper slot on the shield.
6. Move the tab of the rubber roller lock 90° downwards to lock it.
7. Put the shield back in position and secure it.
Operation procedures for taking out printer paper roll:
Steps 1~2: Same as above.
Steps 3. Roll the loading roller anti-clockwise and pull the paper out.
Steps 4~5: As steps 6~7 above.
User Manual for Vital Signs Monitor
Figure 3.11 A
Measuring key
22
Display screen
Figure 3.11 B