Temp Transducer Connection - Gima 35132 Manual De Uso

‚ Use the ankle wrap to secure the sensor cable on the ankle or leg (see Figure 3.10C). Do not over-tighten.
High ambient light sources such as surgical lights (especially those with a xenon light source), bilirubin lamps,
fluorescent lights, infrared heating lamps, and direct sunlight can interfere with the performance of a SpO
To prevent interference from ambient light, ensure that the sensor is properly applied, and cover the sensor site
with opaque material.
Failure to take this action in high ambient light conditions may result in inaccurate measurements.
If patient movement presents a problem, verify that the sensor is properly and securely applied; move the sensor
to a less active site; use an adhesive sensor that tolerates some patient motion; or use a new sensor with fresh
adhesive backing.
For reusable sensors, follow the sensor directions for use for cleaning and reuse. For single-patient use sensors,
use a new sensor for each patient. Do not sterilize any sensor by irradiation, steam, or ethylene oxide.
Safety Information for SpO
Continuous use of the SpO
M
microcirculatory problem. It is recommended that the sensor should NOT be applied to the same place for
over two hours, change the measuring site periodically if necessary.
Ø The SpO measuring site must be examined carefully for certain patient groups. Do NOT place the SpO
2
sensor on the finger of a patient with edema or fragile tissue.
% If sterile packaging of a disposable SpO
% Check the SpO sensor and cable before use. Do NOT use a damaged SpO
2
% If the temperature of SpO
Please do not allow the cable to be twisted or bent.
M
Do NOT put the SpO
M
SpO measuring and cause an alarm error.
2
M Using nail polish or other cosmetic product on the nail may affect the accuracy of measurement.
M The fingernail should be of normal length.
M The SpO sensor cannot be immersed in water, alcohol or cleanser completely, because the sensor has no
2
capability to resist the harmful ingress of water.
M For the range of the peak wavelengths and maximum optical output power of the light by the SpO
see Chapter 6. And this information can be especially useful to clinicians.
M When the SpO signal inadequate, the screen will display "--", even a technical alarm will be generated. And
2
all SpO waveform are NORMALIZED.
2

3.4.4 TEMP Transducer Connection

Please follow the corresponding methods to make temperature measurement according to the temperature
transducer you selected.
User Manual for Vital Signs Monitor
Figure 3.10C Right foot view
Monitoring
2
sensor may result in discomfort or pain, especially for those with
2
sensor is damaged, do not use it.
2
sensor is abnormal, do not use it any more.
2
sensor and pressure cuff on the same limb, otherwise the NIBP measuring will affect
2
Foot wrap
Ankle wrap
sensor.
2
21
sensor.
2
2
sensor,
2