Abicor Binzel iCAT Instructivo De Servicio página 57

iCAT
6.5 Mounting the liner
NOTICE
• Only if the cable assembly connection has been inserted correctly can it
be fastened with the fastening screw.
7 Slide corrugated hose at the cable assembly (3) into the corrugated hose
clamp (6) as far as it will go and clamp with cylinder screws.
NOTICE
• Press the corrugated hose into the corrugated hose clamp and rotate it
until it is rotating in the corrugated hose clamp.
Carry out further activities starting with the following step:
 11 Fasten wire feeder (1) on wire feeder mount (3). on page EN-18
NOTICE
• New still unused liners have to be shortened to the actual length of the
cable assembly.
• For handling the liners, please observe the enclosed wire guide liner
mounting instructions.
• Strip 350 mm of the insulation sheathing of the liner, from the front end
after determining the correct length.
6 Putting into operation
EN - 21