Abicor Binzel iCAT Instructivo De Servicio página 61

iCAT
6.9 Attaching the ROBO WH torch neck
1
1 ROBO WH torch neck
2 Hand lever
Fig. 14 Attaching the ROBO WH torch neck
3 iCAT ROBO WH
4 Clamp clip (in changeable body)
NOTICE
• Do not change the hand lever position during the change procedure! This
will result in malfunctions. The open knife will cause the pre-tensioned
welding wire to expand and to become cut off when actuated next.
These wire pieces will block the locking mechanism and inevitably lead
to failures of the entire system!
1 Insert hand lever (2) through the sealing lips of the clamp clip (4).
2 Move hand lever (2) forward toward the torch neck (1) through the
pressure point as far as it will go.
3 Insert torch neck into changeable body as far as it will go.
4 Move hand lever (2) rearward through the pressure point as far as it will go
and take it after locking.
5
5
6 Putting into operation
2
3
4
Changeable body
EN - 25