CONQUEST PB120LPG Manual Del Usuario página 31

1 Cross struts
2 Dust filter
 Check the dust filter, clean or replace if
necessary.
Note
Exchanging the dust filter may only be
done by the ISAL Customer Service.
 Insert and lock the filter cover.
Check and adjust the V-Belt
The V-Belt must deflect approx. 7-9 mm at
a pressure of 10 kg.
 Get the V-belt tension adjusted by an
authorized customer service.
Check air filter and replace, if necessary
1 Lock
2 Air filter housing
 Remove side panel.
 Remove the air filter housing.
 Replace the air filter insert.
Note: Installation position with blowout
opening pointing down (see illustra-
tion).
Clean the centrifugal separator
1 Wing nut
2 Centrifugal separator
 Unscrew the wing nut from the centrifu-
gal separator.
 Clean the centrifugal separator.
Replacing fuses
1 Lock nut
2 Cover fuse box
 Unscrew the knurled nut.
 Open the cover on the fuse box.
 Check the fuses.
 Replace defective fuses.
Note: Only use fuses with identical
safety ratings.
Note: The fuse FU 01 is located in the en-
gine compartment.
1 Fuse FU 01 (main fuse)
FU 01* Main fuse
FU 02 Horn
Suction blower
FU 03 Multifunction display
FU 04 Beacon lamp
FU 05 Motor control unit
FU 06 Driver cabin (optional)
Wiper
FU 07 LPG filling level display 5 A
FU 08 Starter
FU 09 Left lighting
FU 10 Right lighting
FU 11 Working light
FU 12 Vibrator system
FU 13 LPG valve
Backup signal
* These fuses may only be changed by
Customer Service, as it is necessary to
check the device for potential faults.
13
-
EN
60 A
20 A
3 A
5 A
10 A
10 A
10 A
7,5 A
7,5 A
10 A
25 A
7,5 A
31