Rear Wheel - APRILIA ETV mille Caponord 2003 Libro De Uso Y Mantenimiento

ETVmille_ABS_UK.book Page 73 Friday, October 24, 2003 12:25 PM
2
1

REAR WHEEL

!
CAUTION
The disassembly and reassembly of the
rear wheel may be difficult for unskilled
operators.
It is advisable to contact an aprilia
Official Dealer.
If you want to perform these operations
personally, keep to the following
instructions.
Carefully read p. 60 (MAINTENANCE).
Before carrying out the following
operations, let the engine and the
silencer cool down until they reach
room temperature, in order to avoid
burns.
During disassembly and reassembly
operations, take care not to damage
pipe, brake disc and pads, ABS sensor
(19) and phonic wheel (20).
All manuals and user guides at all-guides.com
7
3
8 9
!
WARNING
Riding with damaged rims may be
dangerous for the rider, other persons
and the vehicle.
Check the conditions of the wheel rim
and change it if it is damaged.
NOTE
For the removal of the rear wheel,
the vehicle must be equipped with the
centre stand !.
DISASSEMBLY
◆
Loosen screw (21) and remove ABS
sensor.
◆
Position the vehicle on the centre stand
(1) !, see p. 58 (POSITIONING THE
VEHICLE ON THE STAND).
◆
Put a support (2) under the tyre, in such
a way as to keep the wheel in its position
after loosening it.
Wheel nut (3) driving torque: 90 Nm (9.0
kgm).
21
19
6
5
13
20
12
5
◆
Loosen and remove the wheel nut (3),
taking the washer (4).
NOTE
wheel pin, slightly raise the wheel.
◆
Withdraw the wheel pin (5) from the left
side.
NOTE
right (6) and left (7) chain tighteners, in
order to be able to reassemble them
correctly.
◆
Take the right (6) and left (7) chain
tighteners.
NOTE
the crown gear (9).
◆
Make the wheel advance and release the
drive chain (8) from the crown gear (9).
◆
Withdraw the wheel from the rear fork
from behind, carefully withdrawing the
disc from the brake caliper.
6
14
11 16
9
7
To facilitate the extraction of the
Check the arrangement of the
Lower the drive chain (8) outside
use and maintenance ETV mille Caponord ABS
10
4
3
73