Changing Password - Roger Technology B70/1DCHP Instrucciones Y Advertencias Para El Instalador

Identi cation number
The identi cation number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
HW version.
Year of manufacture.
Week of manufacture.
Serial number.
FW version.
View manoeuvre counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
Manoeuvres performed.
Example: x100 = 1.234.500 manoeuvres.
View manoeuvre hour counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
Manoeuvre hours.
Example: = 123 hours.
View control unit days on counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
Days with unit switched on.
Example: = 123 days.
Password
Setting a password prevents unauthorised persons from accessing the settings.
With password protection active ( = ), parameters may be viewed, but the values CANNOT be modi ed.
Only a single password is used to control access to the gate automation system.
WARNING: Contact the Technical Support Service if you lose your password.
Password activation procedure:
• Enter the desired values for parameters
• Use the UP and/or DOWN
• Press and hold the + and - buttons for 4 seconds.
• The display ashes to con rm that the password has been saved.
• Switch the control unit off and on again. Check that password protection is activated ( = ).
Temporary unlock procedure:
• Enter the password.
• Check that = .
Password cancellation procedure:
• Enter the password ( = ).
• Save the values , ,
• Use the UP and/or DOWN
• Press and hold the + and - buttons for 4 seconds.
• The display ashes to con rm that the password has been cancelled (the values
indicate that no password is set).
• Switch the control unit off and on again.

Changing password

Protection deactivated.
Protection activated.
, , and
buttons to view the parameter
, =
buttons to view the parameter
to .
Example:
to multiplied by 100.
to .
to .
.
.
.
, , and
75