Changing Password - Roger Technology H70/200AC Instrucciones Y Advertencias Para El Instalador

Password
Setting a password prevents unauthorised persons from accessing the settings.
With password protection active ( = ), parameters may be viewed, but the values CANNOT be modified.
Only a single password is used to control access to the gate automation system.
WARNING: Contact the Technical Support Service if you lose your password.
Password activation procedure:
• Enter the desired values for parameters
• Use the UP
• Press and hold the + and - buttons for 4 seconds.
• The display flashes to confirm that the password has been saved.
• Switch the control unit off and on again. Check that password protection is activated ( = ).
Temporary unlock procedure:
• Enter the password.
• Check that
Password cancellation procedure:
• Enter the password ( = ).
• Save the values
• Use the UP
• Press and hold the + and - buttons for 4 seconds.
• The display flashes to confirm that the password has been cancelled (the values
indicate that no password is set).
• Switch the control unit off and on again ( = ).

Changing password

Protection deactivated.
Protection activated.
72
buttons to view the parameter
and/or DOWN
= .
, , , =
buttons to view the parameter
and/or DOWN
, , and .
.
.
, , and