Fagor evo CONCEPT Instrucciones De Instalación, Uso Y Mantenimiento página 75

hood. The START button (Fig. 9) changes from green to blue at the start of the wash cycle and
flashes during the rinse cycle.
A cycle can also be started by pressing the START button (Fig. 9) with the hood closed.
The wash and rinse temperatures are briefly shown in the DISPLAY (Fig. 9) at the start of the cycles.
In the lower band of the display, a decreasing bar indicates the percentage of the cycle remaining (if
the cycle is extended by the thermo-stop or a regeneration, the bar stops until the rinse has been
completed).
When the wash cycle ends, the START button (Fig. 9) changes to red and the DISPLAY (Fig. 9)
indicates that the cycle has ended. When the hood is opened, the message disappears and the
START button (Fig. 9) changes to green.
The cycle selected will remain selected until the selection is changed, or the appliance is switched
off.
To stop the active cycle at any time, press again the START (Fig. 9) button and the cycle will stop
immediately.
If the hood is opened during a wash cycle, the cycle will pause and continue after the hood is closed
again.
In the models with EFFI-RINSE SYSTEM (Mod "B" & MOD "C") the RINSE LIGHT (Fig. 8 & 9) lights up
when a rinse is run at temperatures which guarantee the correct hygienisation in accordance with health
regulations and at a constant rinse pressure.
When the wash cycle ends, open the hood and remove the basket, allowing the dishes to dry by evaporation
for a minute.
• Remove the basket from the appliance and handle the dishes/cutlery with gloves or clean hands to
prevent contamination. Be careful as the dishes will be hot.
• Do not dry the dishes with kitchen towels or cloths that are not sterile.
• Operators must strictly observe all hygiene requirements when handling clean dishes and cutlery.
Selecting the wash cycle:
P1 - Short
CO-110 90s
CO-142 55s
COP-144 55s
P1 - Short
AD-125 55s
Tank
temperature
Boiler
temperature
The cycle should be selected according to the dirt on the dishes:
Short cycle (for dishes which are not very dirty)
Medium/standard cycle (for fairly dirty dishes)
Long cycle (for very dirty dishes or dishes with dried-on dirt)
PG (Glass Programme): Glass wash cycle with rinse temperature of 65 ºC / 149 ºF.
In the MOD "C" model, the technical service may modify the following parameters in any of the cycles at
the request of the user and under their responsibility:
RED: Machine getting ready (filling and/or heating).
GREEN: Machine ready.
BLUE: Cycle running.
It is NOT recommended to open the hood while a wash cycle is running. There
is risk of exposition to splashing and can result in a poor washing.
Wait for the cycle to finish or stop it by pressing the button of the cycle in
progress, and then use a full wash cycle again.
P2 - Medium
120s
75s
75s
P2 - Medium
75s
55 - 65 ºC / 131 - 149 ⁰F
80 - 85 ºC / 176 - 185 ⁰F
P3 (3 seconds) -
P3 - Long
Extended
180s 10min
120s 10min
120s 10min
P3 - Long PL - Extended
120s 8min
-
-
PG - Glass
90s
65 ºC / 149 ºF
75