Fagor evo CONCEPT Instrucciones De Instalación, Uso Y Mantenimiento página 79

FAULT POSSIBLE CAUSE
The appliance does not receive mains
power.
Machine does
not come on.
Blown fuses.
Interruption to the supply of water or the
intake water valve is closed.
Rinse nozzles blocked.
Water does not
enter the
Solenoid valve filter blocked.
machine.
Faulty solenoid valve.
Rinse pump faulty
Pressure switch broken.
There is no detergent.
Insufficient detergent.
Wash distributors obstructed.
Dirty filters.
Presence of foam.
Incorrect wash.
Temperature in tank less than 50 ºC /
122 ºF.
Cycle length too short.
Water too dirty.
There is no rinse aid
Insufficient rinse aid.
Dishes and
Dishes left inside dishwasher for too
kitchenware are
long.
not dry.
Rinse temperature lower than 80 ºC /
176 ⁰F.
Too much rinse aid.
High water hardness.
Dishes stained
SOFT models: Not enough salt in salt
or scratched.
deposit or incorrect regeneration.
Traces of salt in tub.
Machine stops Check whether the magneto-thermal
during circuit breaker or the differential switch
operation. has tripped.
Machine stops Overflow incorrectly mounted.
and fills with
Pressure switch pipe blocked.
water when it is
Pressure switch faulty.
washing.
Machine does
Hood not closed properly.
not start with
the wash cycle.
Hood closed sensor faulty.
Machine does
Machine not levelled correctly.
not drain
completely.
Pressure switch faulty.
ACTION
Check whether the magneto-thermal circuit breaker
or the differential switch has tripped.
Call the technical service to have it replaced and the
cause analysed.
Check whether there is water in the main system and
open the shut-off valve.
Clean the nozzles. If there is a build-up of lime on the
arm, contact the technical service to have the
appliance cleaned.
Call the technical service to have it cleaned.
Call the technical service to replace it.
Call the technical service to replace it.
Call the technical service to replace it.
Fill the rinse aid container.
Call the technical service to reset the dispenser.
Clean distributors thoroughly.
Clean the filters thoroughly.
Inadequate detergent. Change detergent.
Too much rinse aid. Call the technical service to reset
the dispenser.
Faulty thermostat or incorrect setting. Contact the
technical service.
Select a longer cycle in accordance with the dirt on
the dishes.
Drain the wash tub and fill with clean water.
Fill the rinse aid container.
Call the technical service to reset the dispenser.
Remove the dishes at the end of the wash cycle and
leave to dry by evaporation for a minute.
Allow the boiler to reach the rinse temperature before
starting the cycle. If the problem persists, call the
technical service.
Call the technical service to reset the dispenser.
Check the water hardness, it should be less than 10
ºfH.
Top up salt container.
If necessary, contact the technical service for the
adjustment of the water hardness setting.
When filling the salt deposit, take care not to spill salt
in the tub and clean thoroughly.
Reset safety device and if it trips again, call technical
service.
Mount overflow correctly.
Empty the tub and clean thoroughly.
Call the technical service to replace it.
Close the hood properly. If the hood opens on its
own, contact the technical service to have the
tensioners tightened.
Call the technical service to have it repaired.
Level the machine. In the event of doubt, please
contact your technical service.
Call the technical service to replace it.
79