Wash Cycle - Fagor evo CONCEPT Instrucciones De Instalación, Uso Y Mantenimiento

EN
• Wash glassware first.
• Insert the plates at an angle with the inner side of the plate facing upwards in the rack basket.
• Place wineglasses, cups and glasses upside down in the basket.
• Plan cutlery in the cutlery baskets, handles down, (different types of cutlery can be mixed), and place
the cutlery baskets in the base basket.
• Do not overload baskets.
• Dishes should be washed as soon as possible after use to prevent the dirt from drying on them.

5.10 Wash cycle

The machine cycle includes a wash, drainage, and a final rinse.
The tank thermostat maintains the wash water temperature and a motor pump sends this water with
detergent to the washing arms. The jets of water reach the dishes from different directions in order to
guarantee a uniform wash.
Between the wash cycle and the rinse cycle there is a pause of a few seconds to allow the detergent to
drain off the dishes into the wash tub. If the appliance has a drainage pump, part of the water is drained
from the tub and replaced by clean rinsing water.
Lastly, the dishes are rinsed with mains water heated to between 80 ºC - 85 ºC / 176 ºF - 185⁰F to remove
the detergent from the dishes and at the same time regenerate the water in the wash tank, making it less
dirty.
Models MOD "A" & MOD "B"
The device always starts by default with the P2 cycle selected.
To select another cycle, with the hood open, press the for the cycle you wish to use P, P1, P2, P3,
P3-3 seconds (Fig. 7 & 8). If you want to use the longer EXT.WASH cycle, press P3 (Fig. 7 & 8) for
more than 3 seconds.
Once the wash cycle has been selected, the basket with the dishes must be inserted and the hood
closed. When closing the hood, or if we press a cycle button with the hood closed, the wash cycle
will start immediately. The pilot light L, L1, L2, L3 (Fig. 7 & 8) corresponding to the cycle selected
flashes while the cycle is running.
The cycle used will remain selected until the selection is changed, or the appliance is switched off.
As long as the tank temperature is kept at a washing suitable temperature the pilot light will stay on,
if the tank temperature drops too low the pilot will go out.
To stop the active cycle at any time, press again the cycle button P, P1, P2, P3 (Fig. 7 & 8)
corresponding to the cycle in progress, and the cycle will stop immediately.
If the hood is opened during a wash cycle, the cycle will pause and continue after the hood is closed
again.
MOD "C" models
The MOD "C" model always starts with P2 selected by default. To change the wash cycle (P1, P2,
P3, PL, PG) press MENU (Fig. 9) and the cycle selected is displayed with its length in the DISPLAY
(Fig. 9). Once the wash cycle has been selected, insert the basket with the dishes and close the
74
X
The hood must be fully closed in order to run the wash cycle.