Hrs Models With Steam Condensation; Mod "C": Energy Saving Function; Drainage And Switching Off The Machine - Fagor evo CONCEPT Instrucciones De Instalación, Uso Y Mantenimiento

EN
Wash temperatures →[55-71 ºC] / [131-159 ºF]
Rinse temperatures →[65-85 ºC] / [149-185 ºF]
Cycle times → Wash: P1: 39s→[35s-60s] / P2: 59s→[55s-80s] / P3: 104s→[100s-500s] /

5.10.1 HRS models with steam condensation

In models with the HRS system, it starts up together with the rinse and continues to run for about 25-30
seconds after the end of the cycle. In this way, improved energy efficiency is achieved and most of the
steam is eliminated when the hood is opened.
The operation of the HRS is shown on the display after the end of the cycle (HR is shown in MOD "B"
models with display and HRS in MOD "C" models). After the end of the cycle, you can open the hood even
if the HRS system is active, but if you let the HRS system work you will find a significantly lower amount of
steam.
In MOD "A" models without display, the cycle indicator light will continue to flash while the HRS system is
active.
The HRS system time is configurable between 30 and 60 seconds (40 seconds by default) from the
beginning of the rinse, in models with display / temperature indicators: consult the technical service.

5.10.2 MOD "C": Energy saving function:

The MOD "C" model has an energy saving function which operates as follows:
Stand-by mode: When the machine is on stand-by, the boiler maintenance temperature is 5 ºC lower
Saving mode: If the machine does not run a programme in an interval of 30 minutes, the dishwasher

5.11 Drainage and switching off the machine

At the end of the working day or when it is necessary to change the wash water because it is too dirty, the
wash tank should be drained.
IMPORTANT: WAIT AT LEAST 10 MINUTES AFTER SWITCHING OFF THE MACHINE BEFORE
Models MOD "A" & MOD "B"
The dishwashers have two types of drainage: gravity drainage or using a drainage pump.
Drainage by gravity
If the drain is lower than the appliance drainage pipe, just switch off the machine and remove the overflow
pipe to allow the water to flow freely under gravity.
Drainage using the drainage pump
The pump may be ordered prior to the purchase of the machine or installed subsequently. MOD "C"
models are fitted with a drainage pump as standard.
For correct drainage with the drainage pump, the height of the drain must not
be more than 600 mm above the level of the machine drainage.
If the appliance has a drainage pump and the drain is higher than the machine drainage pipe, the drainage
method is as follows:
• Remove the overflow valve.
• Just press and hold P / P1 (Fig. 7 & 8) for 3 seconds with the hood open, and the drainage cycle
will start immediately. The L / L1 Pilot Light comes on (Fig. 7 & 8) while the cycle is running.
• On completion of the drainage the machine turns itself off and the overflow pipe can be put back
in place.
Switching off the machine
• Just press and hold ON/OFF (Fig. 7 & 8) for 2 seconds.
76
PL: 464s→[100s-500s] / PG: 74s→[70s-95s]
Rinse: 11s [10s-14s]
than the setting temperature.
switches to "Saving mode". In this mode, the boiler maintenance temperature is 10 ºC
lower and the tank temperature 5 ºC lower than the setting temperatures.
CLEANING THE INSIDE OF THE APPLIANCE.