Publicidad
Idiomas disponibles
Idiomas disponibles
6.2 - LEARNING WITH THE HIDDEN KEY OF A TRANSMITTER ALREADY MEMORIZED
With stationary automation it is possible to press the hidden button of an already learned transmitter to open the radio memory of
the control unit. This is equivalent to pressing the «UP» button on the control unit.
Then follow the learning procedure from point 3 to 5 of the previous paragraph.
6.3 - CANCELLATION OF A SINGLE TRANSMITTER
Make sure that the board is out from any programming menus.
1.
To quit, press briefly the "MENU" button until the display shows the state
of the control unit.
Press and release the "UP" button or the hidden key of a transmitter
2.
already memorized. The display shows rad.
Press at the same time the hidden key and the 1st key of the transmitter
3.
that you want to delete within 10 seconds.
4.
If the deleting has been successful, the display shows CLR.
After 2 seconds the display will show the memory location of the deleted
5.
transmitter (for example 235).
WARNING! - after 10 seconds of inactivity, the control unit exits from the learning phase (the display shows tout).
7 - SETTING OF THE STROKE
At the first power up, it is necessary to carry out a learning of the stroke for the acquisition of the stroke length and the slowdown
areas. After this procedure the installation is complete. To customize the automation, proceed as described in the chapter 8.
WARNING!
Be sure that the limit switches are connected and correctly adjusted. Check with the advanced menu def (chapter 4)
if the selected motor type is correct, before carring out the learning.
A = area at running speed.
B = area at slowdown speed.
C = overstroke zone (the movement
is at slowdown speed, if the
slowdown is enabled).
D = intervention zone of the
amperometric sensor with movement
inversion (detects the obstacle).
E = intervention zone of the
amperometric sensor with the stop
of the movement and the setting of
the reached position as total closing/
opening position (resync area).
6-1622399 rev. 1
Intervento
finecorsa
E
C
B
firmware BIOS124P01
UP
UP
D
A
ENG
DOWN
MENU
SS
DOWN
MENU
SS
Intervento
finecorsa
E
B
C
9 / 28
Publicidad
