Allmatic BIOS1 24 POWER Manual De Instrucciones página 41

8.3 - DISPLAY SIGNALLINGS DURING THE FUNCTIONING
DISPLAY DESCRIPTION
RAD
Visualized during the learning of transmitters.
don
Visualized when a new transmitter is memorized or at the end of a reset.
Fnd
Visualized when a key of a transmitter already memorized is stored.
CLR
Visualized when a trasmitter is erased.
LOP
Visualized during the learning of strokes to indicate that the control unit is opening the automation.
LCL
Visualized during the learning of strokes to indicate that the control unit is closing the automation.
L--
Visualized during the learning of strokes if there is an intervention of safety devices.
Visualized when the control unit waits for a transmitter signal, during the function of viewing of the memory
sEE
location.
Visualized when the transmitter is not stored on the memory, during the function of viewing of the memory
Not
location.
tout
Visualized when the control unit exits from the function of viewing of the memory location for inactivity.
power
Visualized when the power supply is not enough.
8.4 - LED SIGNALLINGS
LED COLOUR
RADIO RED
LS1 RED
LS2 RED
POWER ON GREEN
SS GREEN
PAR GREEN
CLOSE GREEN
OPEN GREEN
STOP RED
PH1 RED
PH2 RED
EDGE RED
6-1622399 rev. 1
DESCRIPTION
Led ON with a radio transmission or interferences.
Led is turned on when the limit switch is not activated.
Led is turned on when the limit switch is not activated.
Led normally ON. It shows the presence of the power supply.
Led normally OFF. It is turned on when the button is pressed.
Led normally OFF. It is turned on when the button is pressed.
Led normally OFF. It is turned on when the button is pressed.
Led normally OFF. It is turned on when the button is pressed.
Safety signalling, Led normally ON.
Safety signalling, Led normally ON.
Safety signalling, Led normally ON.
Safety signalling, Led normally ON.
firmware BIOS124P01 ENG 13 / 28