Publicidad
Idiomas disponibles
Idiomas disponibles
8.6 - CHANGE PARAMETERS - ADVANCE MENU
This menu allows a more detailed setting of some parameters.
To enter the ADVANCED MENU, press and hold the "MENU" button for at least 5 seconds.
To change the parameters, proceed as described for the BASIC MENU.
WARNING - after 2 minutes of inactivity, the control unit exits automatically from the menu.
PARAMETERS
Intervention mode of the current sensor:
0 = disabled.
snm
1
1 = complete (limit switch + obstacle).
2 = only obstacle detection in any point of the stroke.
3 = only end of the movement in any point of the stroke.
sit
2
Intervention time of the current sensor.
The disabling time of the current sensor during the start of the
sdt
3
motor.
Acceleration ramp amplitude:
0 ... 30 = ramp amplitude.
ura
4
SSr = single step at 50% of the running speed.
Hsr = single step at 100% of the running speed.
dra
5
Deceleration ramp amplitude.
Functioning of closing photocell (PH1) moving from closed:
sph
6
0 = check PH1.
1 = the automation opens also with PH1 obscured.
Functioning of opening photocell PH2:
ph2
7
0 = enabled in opening and closing.
1 = enabled only in opening.
Photocells test:
0 = disabled.
tph
8
1 = enabled on PH1
2 = enabled on PH2
3 = enabled on PH1 and PH2
Safety edge type:
edm
9
0 = mechanical contact (NC).
1 = resistive (8k2).
Operation mode of safety edge:
0 = working only in closing with inversion of movement.
ied
10
1 = stops the automation (both opening and closing) and free the
obstacle (short inversion).
ebt
11
Decelleration ramp due safety edge intervention.
ert
12
Time of movement inversion due safety edge intervention.
6-1622399 rev. 1
DESCRIPTION
firmware BIOS124P01
1
1
2
2
ENG
DEFAULT
KALOS
MIN
MAX
XL 24
POWER
2
0
3
2
1
10
15
1
30
5
0
30
10
0
30
1
0
1
0
0
1
0
0
3
1
0
1
1
0
1
100
0
100
20
0
20
UM
x 100
ms
x 100
ms
x 100
ms
x 100
ms
x 10
ms
x 100
ms
17 / 28
Publicidad
