Descargar Imprimir esta página

Allmatic BIOS1 24 POWER Manual De Instrucciones página 39

Ocultar thumbs Ver también para BIOS1 24 POWER:

Publicidad

Idiomas disponibles

Idiomas disponibles

7.2 - ADVANCED SETTINGS OF THE STROKE
With personalized learning, the slowdowns will have to be set during the learning procedure and the amplitudes in the two direc-
tions will be independent.
Before starting the procedure make sure you have installed the electric limit switches and have them properly
adjusted.
Make a check of the settings and eventually customize them.
Set the parameter LSI = P in the base menu (chapter 8.5).
Unlock the automation and move it to the middle of the stroke.
1.
Press at the same time the "UP" and "MENU" buttons for at least 5
seconds until the display shows LOP.
If the automation DOESN'T MOVE in opening, press the "DOWN" button
2.
to stop the learning. The display shows L--.
Press the "SS" button to restart the procedure: the automation moves in
3.
opening, at reduced speed, until it reaches the limit switch. In this phase
the display shows LOP.
Reached the opening limit switch, the automation moves automatically
in closing, at running speed. When the automation reaches the position
4.
for the beginning of the slowdown, give a Step-by-Step command (SS).
In this phase the display shows LCL.
The automation proceeds at slowdown speed until it reaches the closing
5.
limit switch. The automation moves automatically in opening, at running
speed. In this phase the display shows LCL and then LOP.
When the automation reaches the position for the beginning of the
6.
slowdown, give a Step-by-Step command (SS).
In this phase the display shows LOP.
The automation proceeds at slowdown speed until it reaches the
7.
opening limit switch. In this phase the display shows LOP.
Reached the opening limit switch, The automation moves in closing at
8.
running speed with slowdowns set.
WARNING! In the event of a safety device intervention, the learning is stopped and will appear on the display L--.
Press the "SS" button to start again the learning from the 3rd point.
6-1622399 rev. 1
firmware BIOS124P01
UP
MENU
UP
MENU
SS
UP
UP

UP
ENG
DOWN

SS
DOWN

DOWN
MENU

SS
DOWN
MENU

SS

DOWN
MENU

SS


11 / 28

Publicidad

loading