Publicidad
Idiomas disponibles
Idiomas disponibles
4 - SELECTION OF THE MOTOR
WARNING!
Before executing the learning of the strokes, the memorization of the transmitters and before performing
any other setting, it is necessary to select the motorization in use, this allows to optimize the operation of BIOS1
24 POWER.
ACCESS TO THE ADVANCED MENU VOICE def, select the value corresponding to the motor to be controlled and perform a reset
by completing the countdown on the display. Refer to the following table for the correct selection of the motor.
The procedure is as follows, in the example the KALOS XL POWER motor is selected (0):
WARNING! The procedure performs a restoration of the factory values causing the loss of any customizations. It does not
affect the amplitude of the programmed strokes and the memorized transmitters.
0
KALOS XL POWER
1
KALOS XL POWERSPEED
2
NOT IN USE
>4''
>2''
6-1622399 rev. 1
rilasciare per un istante
release for a while
relâchez pendant un moment
suelte por un rato
bir an için serbest bırakmak
firmware BIOS124P01
>2''
>8''
ENG
5 / 28
Publicidad
