Publicidad
Idiomas disponibles
Idiomas disponibles
PARAMETERS
Cancelling all transmitters. Enter to modify the parameter and
trf
31
then keep pressed the "MENU" button, a count down appears that
ends with don on the display.
SId
32
Not in use.
: WARNING - do not use on the sliding motors.
1
: These values are not suggested for the sliding motors.
2
NOTE - the parameters highlighted in grey depend on the selected motor. In the table are reported the data of the KALOS XL POWER
motor. For more information, refer to chapter 8.7.
1. MODE OF THE SENSOR INTERVENTION SnM
It is possible to select 4 intervention types for the current sensor that detect the motor blocked:
•
snm = 0 : the sensor is disabled.
•
snm = 1 : complete functioning. Intervention for obstacle detection in the central zone of the stroke and intervention for the
ends of the movement in the areas near the limit switch. Do not use with sliding gates.
•
snm = 2 : the sensor intervenes only for obstacle detection in any position.
•
snm = 3 : the sensor intervenes only as end of the movement in any position. Do not use with sliding gates.
2. INTERVENTION TIME OF THE SENSOR SiT
Time after which intervenes the sensor for the motor blocked detection (current sensor) with an obstacle.
3. DISABLING TIME DURING THE START OF THE MOTOR SdT
Time in which the current sensors is disabled during the start of the motor.
4. ACCELERATION RAMP URA
This parameter allows to set the acceleration ramp amplitude during the start of the motor. Higher is the value and longer will be the
ramp. With UrA = 0, the ramps are disabled and the motor starts directly at the running speed or at the slowdown speed, depending
on the position during the stroke.
In addition to the numerical values, there are 2 additional options:
•
SSr : the motor starts at the 50% of the running speed for 0,6 seconds.
•
HSr : the motor starts at the 100% of the running speed for 0,6 seconds.
5. DECELERATION RAMP drA
This parameter allows to set the deceleration ramp amplitude from the running speed to the slowdown speed. Higher is the value
and longer will be the ramp.
6. FUNCTIONING OF PH1 FROM CLOSED POSITION SPh
The closing photocell has the following functioning:
•
Closing: immediate inversion of the movement.
•
Opening from an intermediate position: no intervention.
•
Opening from closed position:
– Sph = 0 : the automation doesn't move if PH1 beam is cut.
– Sph = 1 : the automation moves also if PH1 beam is cut.
7. FUNCTIONING OF PH2 Ph2
The opening photocell has the following functioning:
•
Opening: stops the movement and waits until the beam is freed, then moves in opening.
•
Closing:
– ph2 = 0 : stops the movement and waits until the beam is freed, then moves in opening.
– ph2 = 1 : no intervention.
6-1622399 rev. 1
DESCRIPTION
firmware BIOS124P01
ENG
DEFAULT
KALOS
MIN
MAX
XL 24
POWER
UM
19 / 28
Publicidad
