Publicidad
Idiomas disponibles
Idiomas disponibles
8.5 - CHANGE PARAMETERS - BASE MENU
It is possible to access to the BASE MENU to change the main parameters of the control unit. To enter the menu, proceed as
described below. WARNING - after 2 minutes of inactivity the control unit automatically exits from the menu.
Example of accessing the base menu to modify the tCL parameter.
UP
DOWN
MENU
SS
Make sure that the board is
out from any programming
menus (press briefly the
"MENU" button).
UP
DOWN
MENU
SS
Use the "UP" or "DOWN" but-
tons to change the value.
PARAMETERS
TCL
1
Auto reclosing time (0 = disabled).
TTR
2
Auto reclosing time after transit (0 = disabled).
SEn
3
Obstacle sensitivity with running speed (0 = disabled).
SEL
4
Obstacle sensitivity during slowdowns (0 = disabled).
14 / 28
UP
DOWN
MENU
SS
> 2''
To enter the basic menu,
press and hold the "MENU"
button for at least 2 seconds.
> 2'' - SAVE
< 2'' - NO SAVE
UP
DOWN
MENU
SS
To save the value, press and
hold the "MENU" button for at
least 2 seconds.
To quit without saving, press
briefly the "MENU" button.
DESCRIPTION
UP
DOWN
MENU
SS
Use the "UP" or "DOWN"
buttons to move inside the
menu.
UP
DOWN
MENU
SS
Use the "UP" or "DOWN"
buttons to move inside the
menu.
ENG
firmware BIOS124P01
UP
DOWN
MENU
SS
> 2''
To enter the parameter, press
and hold the "MENU" button
for at least 2 seconds until
the value blinks.
UP
DOWN
MENU
SS
To quit, press briefly the
"MENU" button.
DEFAULT
KALOS
MIN
MAX
XL 24
POWER
0
0
900
0
0
30
40
0
100
60
0
100
6-1622399 rev. 1
UM
s
s
%
%
Publicidad
