Publicidad
Idiomas disponibles
Idiomas disponibles
9 - MALFUNCTION SIGNALLINGS
DISPLAY
eme
Memory error: the external memory not installed or not recognised.
Memory error during the writing: the value x is a number from 1 to 6. In the event of the error, contact the
eex
technical assistance.
eLs
Limit switches error: opening and closing limit switches are busy in the same time.
efO
Impact sensor intervention.
eeD
Safety edge intervention.
eph
Malfunctioning of photocells.
eth
Thermical intervention to preserve the control unit.
fuL
Full external memory.
err
Memory error during functions viewing memory location or cancellation of a single transmitter.
NOTE - The visualization of an error on the display persists until the "DOWN" button is pressed or until another command is
given.
WARNING! The restore from an EEx error must be carried out through one of the 3 buttons of the control unit (UP,
MENU or DOWN).
WARNING! If the supply fuse blows with the motor blocked, check the intervention thresholds of the current
sensor. A correct configuration of the SEN and SEL parameters limits the possibility of failure of the power supply
fuse. To avoid the intervention of the supply fuse in the condition of motor block it is advisable to use the inversion
function on the obstacle.
24 / 28
DESCRIPTION
ENG
firmware BIOS124P01
6-1622399 rev. 1
Publicidad
