Allmatic BIOS1 24 POWER Manual De Instrucciones página 50

29. VIEWING OF THE MEMORY POSITION FOR A SINGLE TRANSMITTER TRS
With the item of the menu trS it is possible to view the memory location in which a transmitter is memorized.
To perform the function, move to trS and then confirm by pressing the "MENU" button. Keep pressed the "MENU" button untill the
display will show SEE, then release the button.
At this point press a button of the memorized transmitter (it does not active any command). The display shows:
• the memory location for 2 seconds, if is memorized;
• the written not for 2 seconds, if is not memorized.
After 2 seconds the display returns to the screen SEE and it will be possible to perform this function with another transmitter.
To exit the function, press the "MENU" button. Otherwise, after 15 seconds without transmission, the control unit exits the function
and shows the written tout.
30. CANCELLATION OF A SINGLE TRANSMITTER TRC
With the item of the menu trC it is possible to delete a single transmitter from the memory.
To perform the function, move to trC and then confirm by pressing the "MENU" button. Keep pressed the "MENU" button untill the
display will show 0, then release the button. Select the memory location of the transmitter. Press and hold the "MENU" button untill
the display will show CLr, then release the button.
To exit the function, press the "MENU" button. If the display shows the written ERR there are problems with the memory (for example
empty position or disconnected memory).
31. CANCELLING ALL THE TRANSMITTERS TRF
With the item of the menu trf it is possible to erase all the transmitters learnt.
Move to trf, then keep pressed the "MENU" button until the display shows 0, then release the button. Press again and keep pressed
the "MENU" button, the display will show a count down d80, d79, ..., d01 do not release the button until the display showns don.
32. PARAMETER sId
Not in use.
22 / 28 ENG firmware BIOS124P01 6-1622399 rev. 1